Setting IP parameters for the Nortel Ethernet Routing Switch 4500 Series
39
You can use any terminal or PC with an appropriate terminal
emulator as the management station.
" Terminal emulation settings"
lists the parameters that you must use with any terminal
emulation software used to connect to the switch.
Terminal emulation settings
Property
Value
Baud Rate
9600 bps
Data Bits
8
Stop Bits
1
Parity
None
Flow Control
None
You require a console cable and connector to match the male DTE
connector (DB-9) on the switch to connect the terminal to the switch
console port.
2
Set the terminal protocol on the terminal or terminal emulation
program to VT100 and VT100/ANSI.
3
Connect to the switch using the terminal or terminal emulation
application.
4
When the switch configuration is set to factory default the following
screen appears. Enter the information requested at each prompt.
CLI Quickstart welcome screem
Welcome to the 4548GT-PWR setup utility. You
will be requested for information to initially
configure for the switch. When finished the
information will be applied and stored in
the switch NVRAM.
Once the basic parameters
are configured, additional configuration can
proceed using other management interfaces.
Press ^C to abort at any time.
The in-band IP Address prompt line appears
Please provide the in-band IP Address[0.0.0.0]:
10.127.232.30
The in-band sub-net mask prompt line appears
Please provide the in-band sub-net mask[0.0.0.0]:
255.255.255.0
The Default Gateway prompt line appears
Please provide the Default Gateway[0.0.0.0]:10.1
27.232.1
Nortel Ethernet Routing Switch 4500 Series
Installation Guide
NN47205-300
02.01
Standard
5.0
23 February 2007
Copyright © 2007, Nortel Networks
Nortel Networks Confidential
.
Summary of Contents for 4500 Series
Page 59: ......
