Nortel 425-24T, Configuration Manual, Page: 289 / 488

Chapter 7 System configuration using the CLI 289
System Configuration Guide
Setting time on network elements using Simple Network
Time Protocol
The Simple Network Time Protocol (SNTP) feature synchronizes the Universal
Coordinated Time (UTC) to an accuracy within 1 second. This feature adheres to
the IEEE RFC 2030 (MIB is the s5agent). With this feature, the system can obtain
the time from any RFC 2030-compliant NTP/SNTP server.
• “show sntp command”
• “Displaying system information” on page 273
• “sntp enable command” on page 290
• “no sntp enable command” on page 290
• “sntp server primary address command” on page 291
• “sntp server secondary address command” on page 291
• “no sntp server command” on page 292
• “sntp sync-now command” on page 293
• “sntp sync-interval command” on page 293
show sntp command
The
show sntp
command displays the SNTP information, as well as the
configured NTP servers. The syntax for the
show sntp
command is:
show sntp
The
show sntp
command is in the privExec command mode.
The
show sntp
command has no parameters or variables.
Figure 108 displays sample output from the
show sntp
command.
Note:
If you have trouble using this feature, try various NTP servers.
Some NTP servers may be overloaded or currently inoperable.