Using the BayStack 410-24T 10BASE-T Switch
3-120
309985-C Rev 00
•
A configuration file obtained from a standalone switch can be used only to
configure other standalone switches that have the same software revision and
model type as the donor standalone switch.
You can check your switch’s current software revision using the System
Characteristics screen (see
“System Characteristics
” on
page 3-15
).
•
A configuration file obtained from a stack unit can be used only to configure
other “mirror-imaged” stacks. For example, the “new” stack must have the
same number of switches and model types (in the same unit number locations)
and the same software version as the stack in which the donor stack unit
resides.
You can check your switch’s current software revision using the System
Characteristics screen (see
“System Characteristics
” on
page 3-15
).
Reconfigured stacks are configured according to the unit order number of the
donor unit. For example, the configuration file parameters from a donor unit
with physical ID x are used to reconfigure the unit with physical ID x.
•
The configuration file also duplicates any settings that exist for any MDA that
is installed in the donor switch.
If you use the configuration file to configure another switch that has the same
MDA model installed, the configuration file settings will also apply to and
override the existing MDA settings.
Table 3-44.
Parameters Not Saved to the Configuration File
These parameters are not saved:
Used in this screen:
See page:
In-Band Stack IP Address
IP Configuration/Setup
3-8
In-Band Switch IP Address
In-Band Subnet Mask
Default Gateway
Console Read-Only Switch Password
Console/Comm Port Configuration
3-94
Console Read-Write Switch Password
Console Read-Only Stack Password
Console Read-Write Stack Password
Configuration Image Filename
Configuration File Download/Upload
3-118
TFTP Server IP Address
