Doc No. 702070 Page 2 of 8
Introduction
This instruction manual describes the ACM SA/
SE range of electrically heated and ambient air
curtains. Heated models available are 900mm
in length rated at 6.0kW, 1200mm rated at
7.0kW and 1500mm rated at 9.0kW. Ambient
models available are 900mm, 1200mm and
1500mm in length. They are designed for
mounting
above
doorways
and
similar
entrances, and may be used as space heaters.
All models are supplied with an infrared remote
control unit to operate the fan on/off and/or heat
settings. For further details please refer to
section 6, ‘user instructions’, in this manual.
General
All installations must be in accordance with the
regulations in force in the country of use.
These instructions must be handed to the user
on completion of the installation.
Installers and service engineers must be able to
demonstrate competence and be suitably
qualified in accordance with the regulations in
force in the country of use.
To ensure continued and safe operation it is
recommended that the appliance is serviced
annually.
The manufacturer, offers a maintenance service.
Details are available on request.
Electrical
This unit is suitable for connection to 230/240v
(SA models) 380/415v (SE models) 50Hz AC
supplies.
The unit is supplied with a flying lead ready to
connect to a suitably rated mains supply.
The ACM900SE6 has a full heating load of
6.0kW.
The ACM1200SE7 has a full heating load of
7.0kW.
The ACM1500SE9 has a full heating load of
9.0kW.
WARNING:
FOR SAFETY REASONS THIS APPLIANCE
MUST BE EARTHED.
The unit must be wired in accordance with I.E.E
regulations for the Electrical Equipment of
Buildings and the installer should ensure that a
suitable isolating switch is connected in the
mains supply to the heater.
Health and Safety
Sole liability rests with the installer to ensure that
all site safety procedures are adhered to during
installation, and that personal protective
equipment is used during installation of the
product.
Do not rest anything, especially ladders, against
the product.
Standards
Units conform to the following European CE
directives: EN 60335-2-30:2003, EN 60335-2-
80:2003, EN 50366:2003, EN 60335-1:2002 +
A11:2004, +A1:2004.
1. General Information.
WARNING:
THIS HEATER SHOULD NOT BE
INSTALLED WHERE THERE IS A
CORROSIVE ATMOSPHERE.
