Nortec NH Series, Installation Manual

Page: 11 / 110

10-00
Page 3
2006-09-15
INTRODUCTION
1. PREINSTALLATION
A. RECEIVING & UNPACKING EQUIPMENT
(1) Check packing slip to ensure ALL material has been delivered.
(2) All material shortages are to be reported to NORTEC within 48 hours from receipt of
goods. NORTEC assumes no responsibility for any material shortages beyond this
period.
(3) Inspect shipping boxes for damage and note damages on shipping waybill accordingly.
(4) After unpacking, inspect equipment for damage and if damage is found, notify the
shipper promptly.
(5) All NORTEC products are shipped on an FOB factory basis. Any and all damage,
breakage or loss claims are to be made directly to the shipping company.
2. PACKAGING
A. GENERAL
(1) The equipment packaging is standardized in that each box in the shipment will always
have the same contents. The following paragraphs identify the contents of each box.
B. HUMIDIFIER AND CONTROLS BOX
(1) The typical equipment found in the humidifier and controls box is shown in Figure 2.
The contents of the box are listed on the box. If controls are ordered they will be listed
and small accessories that fit into the box will also be listed on the box.
C. DISTRIBUTOR BOX
(1) Depending on the equipment ordered any of the following distributor box configurations
may be received:
(a) For equipment received if an ASD, BSD, CSD distributor(s) is ordered refer to
Figure 3.
(b) For equipment received if a SAM-e distributor is ordered refer to Figure 4.
(c) For equipment received if a RMBP is ordered refer to Figure 5.
D. ACCESSORIES BOX
(1) Additional accessories such as DWC, DWSP, Filter, and Fill cup extension kits are
shipped in a separate box. Smaller accessories that would fit in the humidifier box are
put in the humidifier box and the box is identified as containing such.