P/N 050197 Rev. A
© 2015 Norsat International Inc.
Page 44 of 57
6) Adjust LNB signal amplification from parameter settings if.
a) AGC value is maxed out during pointing and may result in less optimal pointing results, then
adjust ‘Amplify’ to (0.4V to 0.9V)
b) AGC value of beacon during pointing is observed but was too low for the default lock threshold
value at 7V and failed in pointing, then adjust ‘Amplify’ to (1.1V to 2.0V)
To adjust LNB amplification and lock-hold value, Go to CONFIG – Option – Password ‘
←←←←
’ -
Receiver-Set
