Noritz N-063, Owner'S Manual And Installation Manual

Page: 7 / 30

12 13
1
Press the
Operation button.
How to use
Running /Adjusting Hot Water
Previously set
temperature
(Ex.: 104
°
F)
The temperature will be
indicated on the display.
1
2
<With Operation button Off>
On
<Remote controller display>
On
Caution
High Temperature
To prevent scalding:
•
Check the water temperature by hand before bathing or
showering.
•
When you set the temperature to 140
°
F or 167
°
F, the
display will flash for 10 seconds to remind you that this
is a high temperature.
•
Be careful the next time you use the heater after setting
it at 140
°
F or 167
°
F. Check the temperature setting
before using.
•
Do not allow anyone to change the water temperature
while hot water is running.
Flash for 10 sec light up
4 3
Run hot water.
2
Adjust temperature.
Check the indicator lights.
Hot
Cold
Water temperature
If the remote controller was left set at 167
°
F the last time it was used, the setting will drop to
140
°
F as a safety precaution.
On
(
°
F:
)
The figures shown below are just examples. The actual temperature setting
necessary depends on the usage, the length of piping and the season.
Stop the hot
water.
*Initial setting (factory setting at shipment)=104
°
F
Off
Shower, hot water supply,
etc. Washing
dishes, etc.
Hot water supply, etc.
High
temperature
99 100 102 104 106 108 109 111 113 115 117 118 140 167
If using a mixing valve, set the water
temperature on the remote control
approximately 18
°
F higher than
usual.
( Check the temperature )
if you will not be
changing it.
Temperature above 125 degree can scald.