2
Installation
Nordson Corporation 1994
All Rights Reserved
108 129
Issued 3/94
Manual No. 31
−
13
1.
Install the gun onto a 5/8 in. (15 mm) mounting bar and secure the
mounting bar to a stationary gun stand or reciprocator arm.
WARNING
: This gun can only be used with the cables listed in
this manual, and only with a 100 PLUS
or EXP-100 power
supply. Unauthorized modifications or substitutions will void
your equipment warranty and any agency approvals, and
could cause personal injury or property damage.
2.
Connect powder feed tubing to the tubing adapter on the bottom of
the powder inlet body.
Establish a protected path for the powder feed tubing and
electrostatic cable from the gun to the powder pump and
electrostatic power supply. Make sure that the tubing and cable
cannot be abraded, cut, or run over by heavy equipment such as
forklift trucks.
Mount gun on 5/8”
mounting bar.
Secure cable
and feed tubing to
mounting bar. Allow
slack for movement.
Install end in
power supply
multiplier well.
Install tubing
over adapter and
secure with clamp.
Figure 2. Gun Installation
2. Installation
