6
• Select Program by pressing the Program button. The program
number will flash.
• Use the (+) or (-) buttons to select your program number
(i.e., 1, 2, 3, etc.).
Program button
1
Program Number
• The main menu screen for Home will automatically appear.
If you’re lost at any point, just hit the Foot Pedal once to
return to the Home screen.
Main Menu
4
TIP
Programmed Dispense Mode
5
• For initial setup, make sure you’re in Programmed Dispense mode.
When you’re in Programmed Dispense, the LED light left of the
Manual/Program select button is not lit.
To select Programmed Dispense mode, press the “hand” icon
so the red light is off.
TIP
1
Home Jog
Hand icon
Red Light
OFF = Program
(Red Light On = Manual)
2
Connect Power & Foot Pedal
3
• Connect the power cord provided to the back of the Ultimus IV and
plug into your power source.
• Connect the foot pedal provided to the back of the Ultimus IV.
• Turn unit on; On switch is located at the back of the unit. An “EFD
2800” screen will briefly appear before the Main Menu comes up.
Power cord
Foot pedal
On/Off
7
• Select Volume by pressing the Forward button.
• Use the (+) or (-) buttons to set your deposit volume.
Note: The maximum number of Forward steps is 65,534.
Deposit volume, measured in cc’s, is linked automatically to
forward steps of the stepper motor. When you increase your cc
setting, it automatically increases the number of forward steps.
TIP
Forward button
Deposit Volume
