Tribomatic Magnum Automatic Powder Spray Gun
7
E
2000 Nordson Corporation
All rights reserved
343 547A
Issued 8/00
Manual 37-37
WARNING:
Allow only qualified personnel to perform the
following tasks. Follow the safety instructions in this document
and all other related documentation.
NOTE:
The gun mount should be installed with the hinged portion of the
clamp facing up to prevent the gun from falling when the clamp is
opened.
1. See Figure 1. Install the gun mount (3) on a vertical bar mount.
2. Install the desired sprayhead on the spacer (5) with a clockwise
twisting motion.
3. Place the gun in the gun mount and tighten the clamp.
4. See Figure 2. Attach the ground wire (7) to the ground stud (4).
Tighten the knob.
5. Install the diffuser (6) on the gun.
6. Connect atomizing air 1 tubing (2) onto the diffuser and the labeled
fitting on the rear panel of the control unit.
7. Connect atomizing air 2 tubing (5) onto the diffuser and the labeled
fitting on the rear panel of the control unit.
8. Connect the powder feed hose (1) onto the diffuser and the powder
pump.
9. Adjust the gun-to-workpiece distance and vertical position using the
gun holder as an adjustment point.
3. Installation
