NPE-LF10 and NPE-HF10 Powder Spray Guns
13
Part 108191C
E
2003 Nordson Corporation
12
10
9
11
4
14
1
7
6
5
3
2
8
13
13
11
9
HF10
LF10
12
Figure 3
Resistor and Powder Tube Replacement
1. Cable adapter
2. Rear support
3. Dielectric grease
4. Cover
5. Cable well
6. Insulating tube
7. Resistor and spring
8. Thread adhesive
9. Front support
10. Electrode assembly
11. Nozzle
12. O-ring(s)
13. Powder tube
14. Tube clamp
Electrostatic Cable Replacement
Clean the old dielectric grease from the insulating tube with a round brush
whenever you remove and replace the electrostatic cable without installing
a new resistor kit. Warm two dielectric grease applicators by keeping them
in your pocket for a few minutes or immersing them in warm water. Apply
12
−
14 cc of dielectric grease to the inside of the insulating tube before
installing the cable.
Dielectric grease is available from Nordson Corporation in 10-cc syringes
equipped with a flexible applicator end, 12 to a carton. Refer to
Options
on
page 18 for the carton part number.
Refer to the
Electrostatic Cable Installation
procedure on page 7 for cable
installation instructions.
