NPE-LF10 and NPE-HF10 Powder Spray Guns
8
Part 108191C
E
2003 Nordson Corporation
Powder-Feed Hose Installation
1. Locate the spiral-cut tubing (4) and snap clamp (5) furnished with the
spray gun. Install them over the end of the powder feed hose (2).
2. Connect the powder-feed hose to the spray gun’s powder tube. Secure
the hose to the tube with the snap clamp. Move the spiral-cut tubing up
the hose to prevent it from kinking where it connects to the powder tube.
NOTE:
If possible, the powder-feed hose should be no longer than 8 m
(25 ft). Longer lengths will decrease the flow of powder and may cause
uneven powder spray patterns or puffing.
Cooling Air Connection
Connect
1
/
4
-in. flexible air tubing (3) between a regulated supply of
compressed air and the tube connector in the spray gun.
5
6
4
7
1
2
3
8
9
Figure 2
Gun Installation
1. Reciprocator arm or gun stand
2. Feed hose
3.
1
/
4
-in. air tubing
4. Spiral-cut tubing
5. Snap clamp
6. Gun mounting bar
7. Mounting block
8. Electrostatic cable
9. Cable adapter
