MicroCoat MC800 Series System
14
www.nordsonefd.com [email protected]
800-556-3484 Sales and service of Nordson EFD dispensing systems are available worldwide.
Controller Features
1.
System Pressure Switch
Turns the system air supply On and Off.
2.
Mode Switch
Use Manual/Setup position to prime and test the valves
without running the press.
In the Auto/Run position, the system will spray lubricant
when the press begins stamping.
Press air solenoid must be properly installed to allow
the MicroCoat System to run in Auto/Run mode (refer to
pages 18–19).
3.
Tank Air Pressure
Regulates air pressure in the lubricant reservoir. For most
lubricants, 1.03 bar (15 psi) is a good start.
Minimum setting is 0.83 bar (12 psi).
4.
Nozzle Air
Regulates nozzle air pressure.
Average setting is 0.55 to 0.83 bar (8 to 12 psi). Higher
pressure provides finer spray.
5.
Flow Controls
Provide independent flow control of the lubricant to
each spray valve. Each blue ring on the stem coming
out of the middle of the knob indicates one complete
revolution.
Turn counterclockwise to increase flow.
1
2
3
4
5
