6
Hot melt application head EP 30
P/N 397191B
E
2005 Nordson Corporation
EP 30
Exhausting Adhesive Vapors
Ensure that adhesive vapors do not exceed the prescribed limits. Exhaust
adhesive vapors when necessary. Provide sufficient ventilation of the
location where the application head is installed.
Electrical Connections
WARNING:
Risk of electrical shock. Failure to observe may result in
personal injury, death, or equipment damage.
Laying Cable
WARNING:
Do not pinch cables and check regularly for damage. Replace
damaged cables immediately!
Electrically Connecting Application Head
The application head is connected electrically by inserting the plugs into the
corresponding receptacle of the melter or a terminal box. Secure the plug
with the clamp if necessary.
Connecting Solenoid Valves
Depending on the specific design of the hot melt application system, the
solenoid valves on the control modules are controlled either by an external
power supply, e.g. control unit, or through the solenoid valve control leads of
the heated hose. Secure the plug with the clamp if necessary.
NOTE:
Observe the voltage stated on the ID plate of the solenoid valve.
