Nordson 765105, Manual, Page: 27 / 58

Installation
3-3
E
2001 Nordson Corporation
All rights reserved
Gun Controller
Issued 03/01
P/N 768603B
1. Turn off the power to the unit.
2. Press the SET and TEST keys together and turn on the power.
3. The unit will display PAS000 with the right--hand digit flashing.
4. Type the 3 digit passcode and press ENTER, (this number is
available from NORDSON on application), entry of incorrect
passcode reverts to normal operation.
5. The unit displays CELLS4 with the 4 flashing. Type the number of
sensors connected to the unit and press ENTER.
6. The outputs are activated from the sensors as follows:
CELLS1 All outputs activated from input 1
CELLS2 Outputs 1 and 2 activated by input 1
Outputs 3 and 4 activated by input 2
CELLS3 Output 1 activated by input 1
Output 2 activated by input 2
Output 3 activated by input 3
Output 4 not activated
CELLS 4 Output 1 activated by input 1
Output 2 activated by input 2
Output 3 activated by input 3
Output 4 activated by input 4
7. The unit displays PEAC H with the H flashing, by use of the SET and
RUN keys the polarity of the cell input can be changed, from active
high to active low. Press ENTER to confirm selection. This can be
checked using the display later.
8. The unit displays SOP 00, to set the timeout for conveyor stopped,
key in the number of half seconds for which pulses are to be missing
before the outputs are automatically switched off and press ENTER.
NOTE: Minimum value is 2.
9. The unit displays CLOC00, to set the external clock leave the display
showing CLOC00 and press ENTER. To select internal clock select
the clock rate in pulses per second, within the range of 1 to 50 and
press ENTER.
10. The unit displays 110000. The unit is now asking for the on and off
counts for each output, see programming section.
8. Configuration