8
9
Install Washing Machine
Install Washing Machine
Install Inlet Pipe
1.
Connect the elbow to
the
tap and fasten it
clockwise.
Notes:
after connection, if there
are
any leakage
s
in the
hose, repeat the
steps to connect
the
inlet
pipe.
Check that hose hasn't been kinked or
crushed. Do not modify or sever the water inlet hose.
Unpacking the washing machine
Unpack your washing machine and check if there
has been
any damage during the
transportation. Also make sure that all the items (as shown
on
Page
7
) in the attached bag are
received. If there
is
any damage to the washing machine during the transportation, or
if there are
any item
s
missing, please contact the
NordMende
c
ustomer
s
ervice
t
eam.
Dispose the packing materials
The packing materials of this machine may be dangerous to
children
. Please dispose
of
them properly
so that they are out of
the
reach of children
.
D
ispose the related packing
materials according to the relevant local regulations. Please do no throw the packing
materials away together with daily
household r
ubbish.
Remove transport bolts
Before using this washing machine, transport bolts
must be removed from the
under
side of
this machine.
Please take the following steps to remove the bolts:
1.
Loosen all bolts with
a
spanner and then remove them.
2. Plug
the holes with transport hole plugs.
3.
Keep the transport bolts
safely
for future use.
Select the location
Before installing the washing machine, the location characteri
s
ed as follows shall be
selected:
- Rigid, dry, and level surface (if not level, please make it level
by
referenc
ing
the
following figure “Adjust Leg”)
- Avoid direct sunlight
- Sufficient ventilation
- Room temperature is above 0 C
- Keep far away from heat sources such as coal or gas.
- Make sure that the washing machine
is
not stand
ing
on
the
power cord.
- Do not install the washing machine on
a
carpet
ed
floor.
Adjust Leg
1.
When positioning the washing machine, check
that the
legs are
screwed up to their shortest
point
. If not, please turn them to their original
positions with
your
hand or spanner and tighten
the
nuts with
a
spanner.
2.
After positioning the washing machine, press
all four
corners on
the front
of
the
machine
in
sequence. If the washing machine is not
stable
when pressed,
adjust
the appropriate leg
.
3.
Loosen the lock nut with spanner
and turn the leg
by
hand until it closely contacts the floor. Press the
leg with one
hand and fasten the nut closely to the
underside of the machine
with the other hand.
4.
After being locked properly, press
all
four corners
of the machine again
to make sure that
it
has been
adjusted
properly. If it is still unstable, repeat
s
teps 2 and 3.
2
3
4
1
Raise
Lower
Lock
nut
foot
Connect the inlet pipe as indicated, between an ordinary tap and inlet hose.
Connect Water Supply Hose
−
To prevent leakage or water damage, follow the instructions in this chapter.
−
Do not kink, crush, modify or sever the water inlet hose.
−
For the models equipped with a hot valve, connect it to hot water tap with hot water supply hose.
Energy consumption will decrease automatically for some programmes.
