14
15. Connect the ground wires (E), the 8-pin wires
(F), the 10-pin wires (G), and the four speaker
wires (H). Note: The Upright Wire (81) has 8
pins, the pulse wire (D) has 10 pins, and the
speaker wires (H) have 2 pins.
See the inset drawing. The connectors
should slide together easily and snap into
place.
If they do not, turn one connector and try
again.
IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER.
After all of the wires are connected, pull the
wires tight and tighten the five Cable Ties (99)
around the wires. Make sure that no wires are
resting on any posts other than those with Cable
Ties. Then, cut off the ends of the Cable Ties.
H
E
15
F
81
D
99
Console
Wire
G
81
99
99
16.
See the side view drawing.
Carefully slide the
Console Base Back (104) upward to the hand-
rail assembly (I), and insert the flange on the
Console Base Back into the handrail assembly.
Note: You will need to tip the Console Base Back
(104) so that the flange can fit into the handrail
assembly (I).
Tighten ten #8 x 3/4" Screws (2) into the Console
Base Back (104) in the indicated locations.
2
16
104
2
2
2
104
Side View
Flange
I
