21. Never insert any object into any opening.
22. Unplug the power cord before performing the
maintenance and adjustment procedures
described in this ownerÕs guide. Never
remove the motor hood unless instructed to
do so by an authorised service representa-
tive. Servicing other than the procedures in
this ownerÕs guide should be performed by
an authorised service representative only.
23. This treadmill is intended for in-home
use only. Do not use this treadmill in any
commercial, rental, or institutional setting.
WARNING:
Before beginning this or any exercise program, consult your physician. This
is especially important for persons over the age of 35 or persons with pre-existing health problems.
Read all instructions before using. NordicTrack assumes no responsibility for personal injury or
property damage sustained by or through the use of this product.
Save These Instructions
16
5
Maintenance and Trouble-shooting
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and
follow the steps listed.
If further assistance is needed, please call our Customer Service Department on our freephone number:
0800 616329, Monday through Friday from 8:00 am to 8:30 pm and Saturday from 10:00 am to 4:30 pm.
1. SYMPTOM: THE POWER DOES NOT TURN ON
a. Make sure that the power cord is plugged into a properly earthed outlet. (See
How to Plug in the Power Cord
on page 8.) If an extension cord is needed, use only a 14-gauge cord of five feet (1,50 m) or less in length.
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console. (See step
2 on page 10.)
c. Check the circuit breaker located on the treadmill near the
power cord. If the switch protrudes as shown, the circuit
breaker has tripped. To reset the circuit breaker, wait for five
minutes and then press the switch back in.
d. Check the on/off switch located at the front of the treadmill
near the power cord. The switch must be in the ÒonÓ position.
2. SYMPTOM: THE POWER TURNS OFF DURING USE
a. Check the circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit
breaker has tripped, wait for five minutes and then press the switch back in.
b. Check to make sure that the on/off switch is in the ÒonÓ position. (See 1. d. above.)
c. Make sure that the power cord is plugged in.
d. Remove the key from the console. Reinsert the key fully into the console. (See step 2 on page 10.)
e. If the treadmill still will not run, please contact our Customer Service Department.
.
Tripped
Reset
Tripped
c
Reset
OFF
ON
ÒOnÓ
Position
d
WARNING!
¥ Never allow children to play or run around
treadmill.
¥ Storage latch must be fully engaged before
treadmill is moved or stored.
KEEP HANDS AND FEET AWAY FROM THIS
AREA WHILE THE TREADMILL IS IN OPER-
ATION
CAUTION
IMPORTANT:
Incline must be set at lowest level before fold-
ing treadmill into storage position.
Refer to the drawings below. Locate the indicated decals on the treadmill. The text on the decals is in
English. If English is not your native language, find the sheet of decals included with the treadmill. Peel
off the decals that are in your native language, and press them onto the treadmill in the indicated loca-
tions so that they cover the English decals.
IMPORTANT: If any of the decals is missing or is illegible, please call our Customer Service Department
to order a free replacement decal. Apply the decal in the location shown.
