6
asseMBlY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dis-
pose of the packing materials until assembly is completed. Note: After shipping, there may be an oily substance
on the exterior of the treadmill or on the shipping carton. This is normal. If there is an oily substance on the tread-
mill, wipe it off with a soft cloth and a mild, non-abrasive cleaner.
assembly requires the included hex key and your own Phillips screwdriver and adjustable
wrench .
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is
the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses
is the quantity needed for assembly.
note: some small parts may have been preassembled. To avoid dam-
aging parts, do not use power tools for assembly. extra hardware may be included.
#8 x 3/4" Screw
(1)–4
3/8" Star
Washer (12)–14
3/8" Nut (11)–2
3/8" x 2 3/4" Screw (7)–4
3/8" x 1 3/4" Bolt (6)–1
3/8" x 2" Bolt (3)–1
#8 x 1/2" Ground
Screw (9)–1
3/8" x 1 1/4" Screw (8)–4
1/4" x 1/2"
Bolt (36)–4
1/4" Star
Washer (35)–8
5/16" x 2" Bolt (4)–4
5/16" x 1 1/2"
Bolt (5)–4
3/8" x 2 1/2" Screw (4)–2
3/8" x 1"
Bolt (2)–4
5/16" x 1"
Bolt (2)–4
1.
Make sure that the power cord is unplugged.
Place a piece of cardboard below the rear of the
Frame (56) to protect the floor or carpet.
Attach the Left Wheel Cap (96) to the left side of
the Base (97) with two #8 x 3/4" Screws (1).
attach the right Wheel Cap (not shown) to
the Base (97) in the same way.
1
96
97
1
56
Cardboard