13
11. With the help of a second person, hold the con-
sole assembly (G) near the Handrails (72).
Connect the three ground wires (H) from the
console assembly (G) to the three Console
Ground Wires (76) on the Pulse Crossbar (75).
Next, insert the Upright Wire (80) through the
two indicated looped ties (O).
See the inset drawing. Connect the Upright
Wire (80) to the console wire (I). The connec-
tors should slide together easily and snap
into place. If they do not, turn one connector
and try again. IF YOU DO NOT CONNECT THE
CONNECTORS PROPERLY, THE CONSOLE
MAY BECOME DAMAGED WHEN YOU TURN
ON THE POWER. Then, remove the wire tie (A)
from the Upright Wire.
11
G
O
I
76
76
I
80
H
A
80
72
75
12. Set the console assembly (G) on the Handrails
(72). Make sure that no wires are pinched.
Insert the excess Upright Wire (80) into the con-
sole assembly (G). Then, tighten the two ties (O)
around the Upright Wire and cut off the ends of
the ties.
Attach the console assembly (G) with the four
5/16" x 3/4" Screws (13) that you removed in
step 9 and four 5/16" Star Washers (7); do not
tighten the Screws yet.
12
79
G
O
13
7
13
7
80
72
72
Summary of Contents for 24887C.0
Page 5: ...5 ...
