10
NORDIC
CHAIN SAW ASSEMBLY
Note: After unpacking, check the contents for completeness and possible transport damage. If a part is
missing or damaged, please contact the seller.
• Open the packaging and remove the device carefully.
• Remove the packaging material as well as the packaging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport damage.
• If possible, store the packaging until the warranty period has expired.
INSTALLATION: INSTALLING THE GUIDE BAR AND SAW CHAIN
WARNING! The teeth of the saw chain are very sharp! Protective gloves must be worn during all work
on the chain.
Risk of injury! An incorrectly installed saw chain leads to uncontrolled cutting behaviour by the device!
When fitting chain, observe the prescribed running direction!
• Place the chainsaw on a level surface.
1.
Release the hand wheel and take off the chain cover.
2.
Place the saw chain around the guide bar, starting at the top section of the bar.
Insert the saw chain in the circumferential groove. When inserting the chain, observe
the correct running direction of the chain
3.
Place the guide bar with the elongated hole on the stud bolt and guide bolt on the
chainsaw. Run the saw chain around the chain wheel. (Fig.1)
4.
(a) Put the chain cover’s sign and the adjust knob’s sign in the Vertical alignment.(Fig.2)
(b) Fit the chain cover. Tighten the hand wheel clockwise for fastening the rail and chain cover.(Fig.3)
(c)
The adjust knob adjusting the chain tension.(Fig. 4)
Original Instructions
2020/02
1
Warning!
Always remove the battery pack before making adjustments to the equipment.
Be sure to read the following information before you put the cordless equipment into operation: • Charge the
battery pack with the charger. An empty battery pack requires a charging period of approximately 0.5 to 1 hour.
Chain saw assembly
Note:
After unpacking, check the contents for completeness and possible transport damage.
If a part is missing or damaged, please contact the seller.
• Open the packaging and remove the device carefully.
• Remove the packaging material as well as the packaging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport damage.
• If possible, store the packaging until the warranty period has expired.
Installation: Installing the guide bar and saw chain
WARNING!
• The teeth of the saw chain are very sharp! Protective gloves must be worn during all work on the
chain.
Risk of injury!
• An incorrectly installed saw chain leads to uncontrolled cutting behaviour by the device! When
fitting chain, observe the prescribed running direction!
• Place the chainsaw on a level surface.
1.Release the handwheel and take off the chain cover.
2.Place the saw chain around the guide bar,starting at the top section of the bar.Insert the saw
chain in the circumferential groove.
When inserting the chain, observe the correct
running direction of the chain
Original Instructions
2020/02
1
3.Place the guide bar with the elongated hole on the stud bolt and guide bolt on the chainsaw.
Run the saw chain around the chain wheel.
4. (1)Put the the chain cover’s sign and the adjust knob’s sign in the Vertical
alignment.(Fig.1)
(2) Fit the chain cover. Tighten the handwheel clockwise for fastening the rail and chain
cover.(Fig.2)
(3)The adjust knob adjusting the chain tension.(Fig. 3)
The saw chain must not sag, although it should be possible to pull it 1-2 millimetres away from
the guide bar in the centre of the guide bar.
