Nord Drivesystems B1091, Operating Manual With Installation Instructions

Page: 32 / 60

Motors – Manual with installation instructions
32 B 1091 en-1221
Pos: 82 /Anleitungen/Motoren/B1091 Drehstrommotoren/3. ATEX/Klemmenkastendeckeldichtung [EXE, EXN, 22] @ 7\mod_1431427943472_388.docx @ 218892 @ 3 @ 1
3.2.3 Terminal box cover seals
The terminal box cover gasket is captively mounted on the terminal box cover. Please only use an
original seal when replacing the seal.
If the terminal box is opened during installation, maintenance, repair, troubleshooting or overhaul, the
terminal box cover must be re-fitted after the work is complete. There must be no dirt on the surface of
the seal or the sealing surface of the terminal box frame.
The screws for the terminal box cover must be tightened with a torque according to the list below.
Tightening torques for terminal box cover screws
Thread diameter M4 M5 M6 M8
Tightening torque (Nm) 0.8 - 1.2 1.2 - 1.8 1.5 - 2.5 3.0 – 5.0
Pos: 83 /Anleitungen/Motoren/B1091 Drehstrommotoren/3. ATEX/Motorlage – Besonderheiten [EXE, EXN, 22] @ 7\mod_1431428078044_388.docx @ 218924 @ 3 @ 1
3.2.4 Motor position – special features for IM V3, IM V6
If the end of the shaft faces upwards, e.g. version IMV3, IMV6, a cover must be provided by the
operator / installer, which prevents foreign bodies from falling into the fan cover of the motor (see
DIN EN 60079-0). This must not obstruct the fan from cooling the motor. If the end of the shaft faces
downwards (AS), e.g. versions IMV1, IMV5, the motors are normally provided with a protective cover
on the fan cover. A hand wheel on the second end of the shaft is not permitted.