w w w . h a w k e y e e l e c t r o n i c s . c o m
B ASIC OPER ATION:
Switching the Readings from English to Metric
1. Remove the battery holder as per the instructions in the
“Installing the Batteries” section.
2. While looking into the battery compartment, use a small
screwdriver, or other slender object, to reach into the
battery compartment and move the switch to the LEFT
for Metric readings, or to the RIGHT for English
readings.
3. Replace the batteries as per the instructions in the
“Installing the Batteries” section.
Obtaining Depth Readings
(Depth Reading Mode)
1. Place the sonar sensor side of the device into the
water. Make sure to hold the device perpendicular
to the water surface.
2. Flip the activation switch to the RIGHT.
3. The current water depth will be indicated on the
display:
The depth will continue to update 4 times
per second while the device is left in water
that is between 2.5 and 200 ft deep (.8 and
61 m).
If the device is unable to obtain an accurate
depth reading or if it is removed from the
water “
- - -
” will be displayed.
4. To turn OFF, return the switch back to the center position.
Obtaining Fish Readings
(Fish Finder Mode)
1. If a fish is detected while in the
Depth Reading Mode
, a
fish icon will illuminate on the display.
2. A blinking fish icon may represent the presence of a
school of fish moving though the sonar beam.
N
OTICE
:
The device will not obtain readings through air. You CANNOT stand
on the deck of your vessel and obtain readings unless the device is
in direct contact with the water or you use one of the techniques
described within this manual.
N
OTICE
:
This device will not obtain accurate readings if used in a bucket,
barrel, swimming pool, etc. Closed environments like these create a
sonar bounce effect that the internal software is not designed to
decipher.
Switch
Water Surface
1 X
Fish Icon
