Norco BIS-1280A40, User Manual

Page: 32 / 39

BIS-1280A40 User Manual
USB flash disk)
Enter the USB flash disk directory
：
cd /mnt
Run DO test program in USB flash disk
：
./DO_test
4.1.12 12V Power Control
Corresponding node
：
/dev/power:1
——
/dev/power:2
5.1 ASL-572A V1.0
Following is the front interface location and dimensional drawing of ASL-572A V1.0. Please
be careful during the installation. Improper installation may lead to system failure.
Note: In case of any electrostatic damage caused to some components, please wear
anti-static gloves to install the motherboard.
5.2 Installation Step
Please refer to following steps to assemble your computer
：
1
．
Install other expansion card.
2
．
Connect all signal line, cable, panel control circuit, and power supplier.
Key components of this motherboard are Integrated circuit and these components
could be easily damaged by electrostatic influence. So, before installing this unit, please
always keep the following precautions in mind
：
1
．
Hold the board by edges and don
’
t touch any components, plugs or socket pins.
2
．
Wear anti-static gloves/wrist strap while touching the integrated circuit components
（
such as
CPU
、
RAM,etc.
）
3
．
Put those unused or uninstalled components in static shielding bags or trays.
4
．
Please first check the power switch is off before connecting the power plug.