23
Figure 26 – Cable Configurations: C11, C12, C16 and C03
7.
Connect the 6-pin shroud (
S6
) on the
interface cable (
C12
) to the mating
connector (
T6A
) on
C11
(
Figure 26
).
8.
Route
C12
to the Hardi main lift valve
block.
9.
Insert 2 sets of tees between the
matching Hardi main lift valve
connections in accordance to the labels
on wires.
10.
Connect the 3-pin tower (
T3
) on the
roll pigtail cable (
C16
) to the mating
connector (
S3
) on
C11
.
11.
Connect the wires labeled “
LEFT
” and
“
RIGHT
” on
C16
to the Hardi left and
right tilt cartridge valve, respectively.
C16 may have labels “CW” and
“CCW” on it in place of
“LEFT” and “RIGHT”.
12.
Connect the 3-pin shroud on
C13
to
the mating connector
(T3)
on
C11.
Insert the tee on
C13
between the
connectors on the bypass valve.
13.
Connect the 6-pin tower on the valve
cable (
C03
) onto the mating connector
(
S6A
) on
C11
.
14.
The connectors on the valve cable
(
C03
) are marked
RIGHT UP
,
LEFT
UP
,
RIGHT DOWN
and
LEFT
DOWN
. Cables labeled with
UP
go
on the same side as the hydraulic hoses.
Figure 27 – Valve Cable Connections
15.
Connect the CAN Node cable (
C02B
)
to the 4-pin AMP plug on
C11
(
Figure
28
).
Summary of Contents for UC4+ Hardi OEM
