16
7
Electrical Installation
1.
Locate the valve module installed on the NORAC valve block. Remove the plugs installed
in positions 7 and 8.
2.
Connect the 2 pin connector on cables C10 into positions 7 and 8 on the valve module.
Connect the other end of cables C10 to the 2 pin connectors on the NORAC expansion
block (V02).
3.
Disconnect and remove the two NORAC roll sensors (small rectangular box with a cable
running from it). See
Figure 14
for locations.
Figure 14: Roll Sensor Locations
4.
Connect the active roll sensor (E05) to the 8-way coupler (E11) where one of the roll
sensors was connected using cable C03 and a 2-way coupler (E12). Plug the unused
connector where the second roll sensor was connected using the 6-pin plug.
