N O R A B O D E O X Y J E T G O O P E R A T I N G M A N U A L
The OXYJET GO treatment
5.3. The infusion (pulsation)
After thoroughly cleansing and drying your face, you can
start the OXYJET GO treatment. Only use the device in
a well-lit, dry place with a mirror. Please note that the
device may not be used in a wet environment, e. g. near
a filled sink, a filled bathtub, a running shower or a filled
swimming pool. Do not allow the device and the power
adapter to get wet. Make sure the necessary preparations
are ready for treatment and your device is ready for use.
Now start with the treatment:
Take 4 to 5 drops of the OXYJET 1 serum, spread it
thoroughly over your complete face and pad in gently.
This way you can supply your skin with oxygen, energy-
giving and pigment-regulating active ingredients,
thus creating the basis for every OXYJET GO treatment.
Eye area
1. Start now with the treatment of the eye area. Spread
1–2 drops of the OXYJET 2 serum below the eye in the
cheekbone area and temple.
Keep a sufficient distance away from the eye (at least
2 cm) in order to avoid contact with the mucous skin
of the eye. If some of the product comes into contact
with the eye, wash out with plenty of water!
2. After applying the OXYJET 2 serum, tighten the skin
area to be treated between the fore and middle fingers
and apply the OXYJET GO nozzle with gentle pressure.
Press the ”Pulse“ button and start to work from the inner
corner of the eye, proceeding step by step to the temple.
Stay on the same skin area for about 3 pressure surges
and continue to slide slowly until you have treated
your entire lower eye area. When done, press the ”Pulse“
button again, and the unit will stop the pulsation.
Put your device back in the storage station. Now repeat
the whole process – apply the product and pulse it in
with your other eye.
3. Spread 1–2 drops of the OXYJET GO 2 serum above
your eyebrow, but not on the moving part of your upper
eyelid. You should also keep at least 2 cm distance to
the eye and treat only the region above the eye, which
is bony backed. Work from the center of the face to the
outside. Stay on the same skin area for about 3 pres-
sure surges and continue to slide slowly until you have
treated your entire upper eye area. When done, press the
”Pulse“ button again, and the unit will stop pulsation.
Put your device back in the storage station. Now repeat
the whole process – apply the product and pulse it in
with your other eye.
26
27
