Now start with the treatment:
Take 4 to 5 drops of the OXYJET 1 serum, spread it thoroughly
over your complete face. The OXYJET 1 serum forms the basis of
every facial treatment.
The treatment of the eye area:
1. Spread 1–2 drops of the OXYJET 2 serum below the eye in the
cheekbone area and temple.
Keep a sufficient distance away from the eye.
2. Tighten the skin area to be treated between the fore and middle
fingers and apply the OXYJET GO nozzle with gentle pressure.
Press the ”Pulse“ button and start to work from the inner corner of
the eye, proceeding step by step to the temple. Stay on the same
skin area for about 3 pressure surges and continue to slide slowly
until you have treated your entire lower eye area.
When done, press the ”Pulse“ button again, and the unit will stop
the pulsation.
Put your device back in the storage station. Now repeat the whole
process – apply the product and pulse it in with your other eye.
3. Spread 1–2 drops of the OXYJET GO 2 serum above your eyebrow,
but not on the moving part of your upper eyelid. You should also
keep at least 2 cm distance to the eye and treat only the region
above the eye, which is bony backed. Work from the center of
the face to the outside. Stay on the same skin area for about 3
pressure surges and continue to slide slowly until you have
treated your entire upper eye area.
When done, press the ”Pulse“ button again, and the unit will stop
pulsation. Put your device back in the storage station.
Now repeat the whole process – apply the product and pulse it in
with your other eye.
4. Swelling in the lower eye area:
Apply 1–2 more drops of OXYJET 2 serum below the eye.
Distribute the product carefully and be sure to observe the mi-
nimum distance of 2 cm to the eye. Press the ”Flow“ button and
glide gently and slowly from the bridge of the nose outwards to
the temple and in front of the ear down to the chin line. Repeat
this 3–4 times very gently. Press the ”Flow“ button again, and the
unit will stop.
Put your device back in the storage station and repeat the whole
process on your other eye.
Possible irritation of the eye mucosa!
When applying the OXYJET 1 and OXYJET 2 sera,
keep a sufficient distance from the eye (approx.
1 cm) to avoid contact of the preparations with
the eye mucosa. If the preparations accidentally
get into the eye, rinse with plenty of water!
During the OXYJET GO treatment keep the device
away from the eye in the "Pulse" and "Flow"
modes (approximately 2 cm) to avoid irritation from
escaping pressure.
WARNING
18
19