4
NookBox
Installation Guide
PSD-29ZBS(R) / PSMD-29ZBS(R) Power Switch Dimmer Series
ZigBee Network Setup
ZigBee Device Guideline
ZigBee is a wireless communication protocol that is reliable, has low power consumption and has high transmission efficiency. Based on the
IEEE802.15.4 standard, ZigBee allows a large amount of devices to be included in a network and coordinated for data exchange and signal
transmission.
Joining the ZigBee Network
As a ZigBee device, the Dimmer needs to join a ZigBee network to receive commands and transmit energy consumption information.
Please follow the steps bellow to join the Dimmer into a ZigBee network.
1. Plug in the Dimmer into a power outlet.
2. Press and hold the function button for 10 seconds as the Dimmer resets and starts searching for existing ZigBee network.
Please make sure the permit-to-join feature on the router or coordinator of your ZigBee network is enabled.
3. If the Dimmer successfully joins a ZigBee network, the LED Indicator will flash twice to confirm.
4. After joining the ZigBee network, the Dimmer will be registered in the network automatically. Please check the ZigBee network
coordinator, system control panel or CIE (Control and Indicating Equipment) to confirm if joining and registration is successful.
Binding with Controller
After joining the ZigBee network, the Dimmer can bind itself with a controller device which can be used to adjust the Dimmer’s power
output level. To bind the Dimmer and the device:
1. Press and hold the Function Button for 3 seconds, then release the button. The Dimmer will send binding request to the coordinator.
2. Refer to your controller manual to send binding request for the device within 16 seconds.
3. If binding is successful, the Dimmer LED indicator will flash 5 times to confirm. You can now use the controller to adjust power output
level for the Dimmer.
4. If binding is unsuccessful, please retry the binding process.
Removing Device from ZigBee Network (Factory Reset)
To remove the Dimmer from current ZigBee network, the Dimmer must be put to Factory Reset to complete device removal. Factory Reset
function will clear the Dimmer of its stored setting and information and prompt the Dimmer to search for new ZigBee network.
Before removing device, make sure the Dimmer is within current ZigBee network signal range.
1. Delete the Dimmer from current control panel / CIE.
2. Press and hold the function button for 10 seconds, then release the button to reset the Dimmer.
3. Upon reset, the Dimmer will clear current ZigBee network setting and transmit signal to ZigBee coordinator to remove itself from current
ZigBee network. It will then actively search for available ZigBee network again and join the network automatically.
ZigBee Router Device Capacity (PSD-29ZBSR / PSMD-29ZBSR Only)
The Dimmer models with Router function allow other ZigBee devices to join the ZigBee Network through the Router. The Dimmer Router
(PSD-29ZBSR) has maximum capacity of 40 devices, including 10 routers; the Dimmer with Meter Router (PSMD-29ZBSR) has maximum
capacity of 5 devices/routers.
