5
NookBox
Installation Guide
Keypad
Power
• Remote keypad uses one CR2 3V Lithium battery as its power source.
• Remote keypad can also detect the battery status. If the battery voltage is low, the Active LED will flash (
Amber in Test mode or Blue
in Normal mode
) during operation. The Low battery signal will be sent along with regular signal transmissions to the Control Panel for
displaying the status accordingly.
• Before shipment, the battery is pre-installed by the factory.
• When changing battery, press the any key a couple times to discharge before inserting new battery.
Power Saving Feature
• When idle, Remote keypad is in
Stand-by
mode and uses no power. It will activate and
wake-up
for 5 seconds when any key is pressed.
• After 5 seconds of key inactivity, the power goes off and it returns to
Stand-by
mode.
• Upon completion of a command input, the power goes off and Remote keypad returns to
Stand-by
mode.
Test Mode
• Remote keypad can be put into Test mode by entering the Keypad PIN code (default:
0000
) followed by
*
key. The Active Amber LED
will turn on along with a long beep.
• To exit Test mode, press
key
twice
, Remote keypad will sound a long beep and the Active LED will turn off, then Remote keypad
returns to Normal Operation mode. Otherwise, Remote keypad will automatically exit Test mode after 5 minutes and return to Normal
Operation mode.
<NOTE>
•
When Remote keypad is in Test mode, it operates as
wake-up
condition and will NOT disconnect after 5 seconds.
Test Mode Function:
» Press
*
key and then
7
key — Transmit Remote keypad learn signal
» Press
*
key and then
2
key — Enable Dual-key Panic Alarm function
» Press
*
key and then
3
key — Enable Dual-key Fire Alarm function
» Press
*
key and then
4
key — Enable Dual-key Medical Alarm function
» Press
*
key and then
5
key — Disable all Dual Key function (Default)
» Press
*
key and then
6
key — Edit Keypad Pin Code
Enter
Old
Keypad Pin Code and then press
key
Enter
New
a new 4-digit Keypad Pin Code and then press
#
key.
» Press
key
twice
— to leave the Test Mode.
» Press
*
key and then
8
key — Enable Arm/ Home without PIN Code function
» Press
*
key and then
9
key — Enable Arm/ Home with Control Panel User PIN Code function (
Default
)
Tamper Protection
• The keypad is protected against any attempt to open the lid or to detach keypad from its mounting surface.
• Tamper protection is disabled when the keypad is in Test Mode.
