Nomadix AG-2000W, User Manual, Page: 93 / 254

N
OMADIX
AG-2000
W
™ / AG-2000
WA
™
System Administration 89
3.
Enable or disable the
DHCP Client
, as required. If you are using a DHCP Client,
you can skip Step 4 through Step 6.
4.
Enter a valid IP address in the
Network IP Address
field.
The Network IP Address is the public IP address that allows administrators to see
the AG-2000w on the network. Use this address when you need to make a
network connection with the AG-2000w.
5.
Enter a valid IP address in the
Subnet Mask
field.
The subnet mask defines the number of IP addresses that are available on the
routed subnet where the AG-2000w is located.
6.
Enter a valid default gateway IP address in the
Default Gateway
field.
The default gateway is the IP address of the router that the AG-2000w uses to
transmit data to the Internet.
7.
When finished, you must reboot the system for the new settings to take effect.
Click on the check box for
Reboot after changes are saved?
to reboot the
system after saving your changes.
8.
Click on the
Submit
button to save your changes and reboot the system, or click
on the
Reset
button if you want to reset all the values to their previous state.
You must reboot the system if you make changes to any of the following
IP settings.
You may lose your connection if you change the IP settings incorrectly
(using invalid IP addresses). If you “misconfigure” the AG-2000w and
network connectivity is lost, you can still access the AG-2000w from the
Admin IP address (172.30.30.172).
All IP addresses must be established, otherwise the AG-2000w will not
be “visible” on the network.