10
11
model no. 043-6174-8 | contact us: 1.866.827.4985
Operation
1. Press the increase button (1)
once until the LED display (2) indicates
the room temperature. The room
temperature indicator (3) will glow.
Adjust the temperature by pressing the
buttons (1) and (4) to increase or decrease
the temperature respectively. The set
temperature indicator (5) will glow.
1. Make sure the humidifier (1) is fully
inserted into the two hooks on the
rear side of the heater (2). Refer to
the section “Installing the humidifier”
on page 8.
2. After the desired temperature is set,
the heater runs on high mode until
the room temperature reaches the set
temperature. The heater will then switch
to low mode for 10 minutes. The heater
turns OFF if the room temperature
is equal to or greater than the set
temperature. The fan will continue to
run for a minute until the residual heat is
expelled.
Auto
5
2
1
4
3
Auto
1
1
2
SETTING THE TEMPERATURE
SETTING THE HUMIDIFIER
NOTE:
Th
e default temperature (factory) setting of the heater is 20 °C.
2. Press the humidifier button (1) to set
the heater to humidifier mode.
3. The humidifier shuts OFF automatically
when the water level is low. Turn OFF
the heater and remove the water
bottle from the humidifier. Fill the
bottle with distilled water and refit it
to the humidifier. Refer to the section
“Installing the humidifier” on page 8.
!
CAUTION:
To prevent leakage, do not move the heater quickly when the humidifier is
filled with water.
For e.g. if the set temperature is 22 °C,
the heater will run on high mode until
the room temperature reaches 22 °C.
The heater will then switch to low mode
for 10 minutes. The heater turns OFF
if the room temperature is equal to or
greater than 22 °C.
1. Press the oscillation button (1) once.
The air outlet (2) will oscillate left and
right.
1. Press the timer button (1) until
the default time “3.0” hours starts
flashing on the LED display. The timer
indicator (2) will glow.
Auto
8.8.
1
2
Auto
2
+
–
1
+
–
1
2
SETTING THE OSCILLATION MODE
SETTING THE TIMER USING REMOTE
CONTROL
NOTE:
Ensure the heater is placed in a stable position so it does not fall over.
2. Press the increase “+” button (1) to
increase the set time or the decrease
“–” button (2) to decrease the set time.
The timer can be set from 1 to 12
hours. When the set time is reached,
the LED display stops flashing and the
heater will shut OFF automatically. The
up “ “ and down “ “ buttons on the
product control panel are also capable
of altering the timer duration after
the timer mode is initiated with the
remote control.
3. To turn OFF the timer, follow step 1,
and press the “–” button until the timer
is set to 0. The timer indicator stops
flashing to indicate that the timer is
turned OFF.
2. Press the oscillation button again to
turn OFF the oscillation mode.
Operation
