EN
18
13.
“UNIVERSAL INTERCOM” INTERCOM
The N-Com B601 system can be connected via Bluetooth to intercom systems of other brands or to
N-Com systems other than the “900” / “600” series, thanks to the UNIVERSAL INTERCOM function.
Important
: N-Com systems other than the “900” / “600” series must be paired up to the N-Com B601
by following the procedure “Pairing up the Universal Intercom”.
13.1.
Pairing up the UNIVERSAL INTERCOM
The N-Com system can be paired up to the other intercom (from now on referred to as Intercom
B
)
as if it was a mobile phone.
Make sure the B601 is turned off.
Put the system in the “Configuration” mode: press the “
ON
” key and keep it pressed for 4
seconds, until you hear the voice announcement “
Configuration
”.
Press the pushbutton “
” until you reach the option “
Universal intercom pairing
” mode.
Put intercom B in the mobile phone pairing up mode (refer to the Intercom B manual).
After a few seconds, Intercom B will emit the confirmation beep.
N.B.:
The system paired up using the UNIVERSAL INTERCOM is saved in the first available channel.
13.2.
Universal Intercom Function
To turn on and off the audio between two helmets, proceed as follows:
From the N-Com B601 system:
Connect or disconnect Intercom B as you would for a regular N-Com intercom (chapter 12).
Intercom B may receive a dialing one that must be answered with a phone reply command.
From intercom B
Press the “
Voice call / Dial last number called
” command.
To disconnect the intercom, press “
Hanging up/rejecting a phone call
” command.
N.B.:
The N-Com B601 systems keeps an active connection with a mobile phone or a GPS even during
Bluetooth communication with other intercom systems.
The intercom system connected to N-Com B601 may not allow simultaneous connection to a
mobile phone.
Only one system paired up in Universal Intercom mode can be stored.
