ASSEMBLY
The device comes disassembled in 2 pieces. To assemble the
device, first remove the small spongy cable protector piece
on the middle shaft and dispose it. Next, engage the shafts
together so that the screw hole is centered in the slot. Pay
attention not to damage the cable during this process. Then,
place the obround piece in the slot with the arch mark facing
upwards. Lastly, tighten the bolt to secure.
To adjust the shaft length to your height, open the lever latch.
Pull the lower shaft down and after adjusting the length, press
the level latch to secure. Do not extend it beyond the ''max''
mark.
To adjust the coil angle parallel to the ground, loosen the nut.
Once adjusted, tighten back to secure.
WARNING! The search coil is NOT detachable, do not attempt
to remove!
Summary of Contents for Mini Hoard
Page 8: ...www noktadetectors com...