GB 7
The box for your Mediamaster should contain the following items:
• the Mediamaster
• remote control with 2 AAA batteries
• SCART cable (fully connected; 1,0 metre)
• mains cable
• RF cable
• Owner’s manual including a software license agreement
Connecting the Mediamaster
SCART socket
Preparing the remote control
• Remove the cover on the battery compartment at the bottom
of the remote control.
• Insert the 2 AAA; 1,5 V batteries, as shown in the diagram, tak-
ing care to observe the
+
and
-
markings indicated inside.
• Replace the cover.
SCART cable
Mains cable
Owner’s Manual
Remote control
RF cable
About the digital transmission
Digital Radio and TV signals can be blocked by buildings, moun-
tains and the terrain. Depending on if the receiver is located in a
valley, behind a mountain or in a concrete building, the quality of
reception may vary considerably.
As with most other transmissions, bad weather does affect the
reception quality.
About the SCART sockets
The rear panel of the Mediamaster is equipped with 2
SCART
sockets (see diagram). When you connect other devices to any
of these sockets, always
use fully connected
SCART cables (as
the one supplied.) There are SCART cables available which do not
have all the pins connected. The picture quality could be reduced
if you use them.
