Nokia WiFi Gateway 3 Product Guide
Replace a Gateway 3 (G-240W-E)
Issue: 01
3FE-47464-AAAA-TCZZA
57
iv
Wind the fiber optic cable through the fiber track at the base of the cylinder until the
desired length of the cable is reached.
v
Press the fiber optic cable into the slot.
vi
Replace the bottom cover.
vii
Replace the fiber optic connection cover (white cylinder).
6
Connect the Ethernet cables directly to the RJ-45 ports; see Figure
RJ-45 ports.
7
Connect the power cable to the power connector.
8
Power up the unit by using the On/Off power button.
9
Verify the LEDs and voltage status.
10
Activate and test the services.
11
If necessary, reset the Gateway 3 (G-240W-E).
i
Locate the Reset button on a Gateway 3 (G-240W-E) as shown in Figure
.
ii
Insert the end of a straightened paper clip or other narrow object into the hole in the
Reset button to reset the device.
12
STOP. This procedure is complete.
Note —
Observe the following:
•
Units must be powered by a Listed or CE approved and marked
limited power source with a minimum output rate of 12 V dc, 3 A. The
polarity of the power adapter plug must match the Gateway 3.
Note —
Resetting the device will return all settings to factory default
values; any configuration customization will be lost.