51/113
<dial-string>
characters
Values Description
V.25ter dialling digits
012*
accepted as valid digits
#ABCD
accepted but ignored
V.25ter modifiers
,
in case of voice call: originate call to the number preceding comma,
wait for remote answer, pause for length specified with
S8
register,
and send numbers after comma as DTMF digits; further commas
cause pause for length specified with
S8
register (all commas are
ignored in case of data call)
T P ! W @
accepted but ignored
V.25ter semicolon
;
NOT supported
: voice call originating (must be the last character in a
command line)
GSM 07.07 modifiers
>
direct dialling from phonebook (must be the first character after
D
)
(see next table)
i
allow calling line id presentation for this call
I
restrict calling line id presentation for this call
G
control CUG information for this call; use
+CCUG
values
de facto
L
redial to the number last dialled
any other character
any of not
listed above
accepted and ignored from command line for compatibility reasons
See also 07.07 section 6.2 and V.25ter sections 6.3.1.1-6.3.1.7. Note that
I
is the only case-
sensitive dial string character.
Direct dialling command
Description
+cme error
D><str>[i/I][G][;]
Originate call to phone number whose corresponding alphanumeric field is
<str>
; search all ME, SIM (ADN) and TA memories (if available) for the entry;
used character set should be the one specified by
+CSCS
x
D>
mem
<n>[i/I][G][;]
Originate call to phone number found from location
<n>
in a specific memory
mem
, which is one of the two letter memory abbreviations as returned by
+CPBS=?
(without double quotes); location range can be queried with
+CPBR=?
; note that in case of SIM ADN memory (
SM
) also
D>SIM<n>
shall be
accepted (due to inconsistency in 07.07)
x
D><n>[i/I][G][;]
Originate call to phone number in memory location
<n>
; memory selected with
+CPBS
is used
x
Direct dialling support is optional. 07.07 section 6.3.
Request GPRS service ‘D’
Description
+cme error
D*99[*[<called_address>
][*[<L2P>][*[<cid>]]]]#
Causes the MT to enter the V.250 online data state and, with the TE, to
start the specified layer 2 protocol.
x
Optional. 07.60 section 10.4.1.1.
Note:
GPRS Phase 1 does not support mobile originated context modification
