Nokia 105s, Installation Manual, Page: 50 / 112

4
Installing and Replacing Network Interface Cards
50 Nokia 105s Gateway Installation Guide
Caution
Protect your 105s gateway and other electronic equipment from
electrostatic discharge (ESD) by making sure you are properly
grounded before touching any electronic components.
Deactivating Configured Interfaces
If you are removing or replacing an installed NIC, use Network Voyager to
deactivate any configured ports on the NIC before removing it.
„
Deactivate all of the logical interfaces on the NIC.
„ Deactivate all of the physical interfaces on the NIC.
If you do not deactivate the interfaces before removing the NIC, you may
have to reinstall the NIC to deactivate its logical and physical interfaces in
Network Voyager.
For information about how to access Network Voyager, see “Using Nokia
Network Voyager” on page 43.
Removing, Installing, and Replacing NICs
Note
Before removing a configured NIC with these instructions, you must
deactivate the NIC in Network Voyager. For additional information, see
“Deactivating Configured Interfaces” on page 50.
Use these instructions to remove, install, or replace a NIC in the 105s
gateway. Some steps are not applicable to all procedures. The instructions
point out steps appropriate to each procedure.