Nokia 105s, Installation Manual

Page: 41 / 112

Using a Console Connection
Nokia 105s Gateway Installation Guide 41
The fans on the back of the gateway turn on when you press the power
switch. Verify that the fans are running after you press the switch.
Check the power LED on the front panel of the gateway (the Nokia logo)
to ensure that the power supply is operating correctly. The power LED
should be illuminated. For more information about the system status
LEDs, see
“System Status LEDs” on page 23.
If the power supply fans are not running, or if the power LED is not
illuminated:
„ Check the power supply cord to make sure it is properly connected.
„ Make sure the power switch is on.
„
Make sure the chassis tray assembly is pushed all the way in from the
front of the gateway and that the front panel retaining screws are
tightened.
„
Make sure that power is turned on to the power strip or wall receptacle
you plugged the gateway in to.
If the fans are still not running, or if the power LED does not illuminate,
contact your Nokia service provider as listed in
“Nokia Contact
Information” on page 3 for technical support.
2. At the console a series of startup messages appears, then the console
prompt appears.
The prompt remains on the screen for about five seconds. If you type any
character during this time, the gateway activates the Nokia IPSO boot
manager.
BOOTMGR[0]>
Note
For information about using the boot manager, see the Nokia IPSO
Boot Manager Reference Guide .
After some miscellaneous output, the following prompt appears:
Hostname?