NOISE COM, INC.
Numeric values for Attenuation, Step Size and Time parameters may be
entered in a 'free-format', and may include a decimal point where
appropriate. Thus, 012.5, 12.5 and 0125 are equivalent, as are
012.0, 12.0, 12 and 0120. Numeric values for Filter setting MUST be
entered as a 4-digit integer, with the most-significant three digits
being zero, and having a range from '0001' (Dummy Load on) through
'0008'. Alternately the Filter setting may be specified as a
decimal point '.' followed by a single digit. Thus, '0003', '0.3'
and '.3' are acceptable and equivalent; '3' alone is not
acceptable. The destination Step Number of a GOTO instruction, used
in Program Entry Mode, must also be entered as a 4-digit number,
with the most significant two digits being zero and having a range
from '0000' through '0015'.
When a Remote Command that directly addresses the Attenuators or
Filters is executed (NA, NF, XA, XF), the MAIN INFORMATION
DISPLAY will show the change to the most recently effected channel
(Noise or external).
COMMANDS:
NAnnnn or NAnnn.n Sets the Noise Attenuator to nnn.n dB.
NSnnnn or NSnnn.n Sets the Noise Step size to nnn.n dB.
NF000n or NF.n Sets the Noise Filter to position 'n'.
NAI Increments the Noise Attenuator by the
Noise Step size.
NAD Decrements the Noise Attenuator by the
Noise Step size.
XAnnnn or XAnnn.n Sets the external Signal Attenuator
to nnn.n dB.
XSnnnn or XSnnn.n Sets the eXternal Attenuator Step size
to nnn.n dB.
XF000n or XF.n Sets the external Filter to pos'n 'n'.
XAI Increments the external Attenuator by
the external Step size.
XAD Decrements the eXternal Attenuator by
the eXternal Step size.
TDnnnn or TDnnn.n Specifies a Time Delay (in seconds).
Pn Causes execution of stored Program #n.
Document M016301
Pg 20
Rev. 2 2/26/03
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com