Nogueira DPM-1, Instruction Manual

Page: 27 / 64

27
Practical guide
Machine is jammed Due excessive intake, the
motor cannot maintain the
required rotation and the
product accumulates inside
the machine Stop the motor, clean the excess
product, start operating again but
ow control the intake to the
machine, so that it does not exceed
the recommended capacity
Low production Not enough intake to the
machine The intake must be continual, but
not excessive, which can cause
jamming
Machine rotation is below
recommended If the rotation of the machine is
below the recommended, the
hammers will take too long to shred
the product and due to this, the
production will drop. Therefore, it is
necessary to maintain the
recommended rotation of the
machine
The product is damp If the products are very damp, the
holes in the sieve can become
blocked. Therefore, shredding must
be done only on dry products
The machine adjustment is
incompatible with the
product being processed It is necessary to check if the sieve
being used is compatible with the
desired final product
Uneven product cutting The blade cutting edge is
not sharp Sharpen the blades again as
recommended in the item on
Sharpening blades
The counter-blade is worn
or not well adjusted Proceed as recommended in the
item on Counter-blade adjustment
It is difficult to grind dry
products The hammers are worn or
damaged Change the sides of the hammers
or change or new ones, proceed as
recommended in the item on
Changing hammers
Hammers are stuck Wash the chutes, blades and
hammers, using water after
chopping fresh products, especially
when not used for extended
periods of time
It is difficult to start the
actuation Excessive product inside
the machine Operate the machine until all the
product comes out
DPM-500/1/2/4
E
n
g
li
s
h