25
Network Type:
specifies the network type for your device. How to select one of them
depends on whether the wireless network need to share data or peripherals with wired
network.
Infrastructure:
this mode allows Wireless LAN and wired LAN to communicate with
each other by one AP. The wireless network bridges to wired network by this mode.
If you choose this type, you can’t edit Channel Width and Channel Number.
Ad hoc:
this mode allows two or more computers with wireless function to
send/receive messages from each other. If you choose this type, you can edit all the
options.
SSID:
Service Set Identifier used to identify your 802.11 wireless LAN should be specified
while operating in AP or AP+WDS mode. All the client devices within the range will receive
broadcast messages from the access point advertising this SSID.
Channel Width:
this is the spectral width of the radio channel. Supported wireless channel
spectrum widths:
20MHz
is the standard channel spectrum width.
40MHz
is the channel spectrum with the width of 40MHz (selected by default).
Control Sideband:
this function is to control the sideband of the radio channel.
Upper:
By default, it is Upper, and the Channel Number is 11.
Lower:
If you choose Lower, the Channel Number will change to
Auto
automatically and you ca
n’t change the Control Sideband at the same time. The
selectable Channel Number now will range from 1 to 9. Only when you choose
other Channel Number you will activate the Control Sideband again. If you choose
Upper, the Channel Number selectable will range from 5 to 13.
Channel Number:
this option provides selectable channel numbers.
Broadcast SSID:
enable this function will allow others search for your SSID and connect to
your wireless network.
WMM:
it is an abbreviation of Wi-Fi Multimedia. It defines the priority levels for four access
categories derived from 802.1d (prioritization tabs). The categories are designed with
specific types of traffic, voice, video, best effort and low priority data.
Associated Client:
Only if you choose AP or AP+WDS Mode, you can activate this button
and check the MAC address, transmission, reception packet counters and encrypted status
for each associated wireless client. See below:
Summary of Contents for NG-192
Page 1: ...1 ...