appliance, the minimum distance between the surface
supporting the cooking elements and the lower part of the
hood must be at least 65 cm. If the installation instructions
for the gas cooker indicate a greater distance, this should be
observed.
• If the extractor hood is installed over an electric cooking
appliance, the minimum distance to be left between the
surface supporting the cooking elements and the lower part
of the hood is described in the assembly plan.
• The regulations with respect to air evacuation must be
respected.
MAINTENANCE
(Figs. 10/11)
Do not open the central glass before 30 minutes after the
lights have been switched off
-Cleaning.
Before any type of operation, always make sure that the
electrical cord is disconnected and the switch is in the off
position. Clean the external part with a mild, liquid detergent
and avoid the use of abrasive cleaning products.
-Changing the light.
Before changing the light make sure that the hood is not
connected.
Remove the grease filter and replace the light with a light
bulb no more powerful than that specified in the Technical
Characteristics. Place the filter in position.
-Cleaning the grease filter.
Depending on use, and at least once a month the grease
filters should be disassembled and cleaned in a dishwasher
or with hot soapy water.
If washed in a dishwasher, the filters should be placed in an
upright position to prevent food remains from falling on
them.
After rinsing and drying, replace the filters by following the steps
for disassembly in reverse order.
The active carbon filters must be replaced periodically to
work properly, at least once every three months (depending
on the frequency with which the hood is used).
IMPORTANT WARNING FOR EXTRACTOR HOODS WITH
HALOGEN LAMPS
If the halogen lamps need replacing, they must be replaced
by lamps with an aluminium reflector, never dichroic lamps,
to avoid unnecessary overheating in the lamp holders.
THE MANUFACTURER WAIVES ALL LIABILITY FOR
FAILURE TO OBSERVE THE INSTRUCTIONS FOR THE
APPROPRIATE INSTALLATION, MAINTENANCE AND
USE OF THE EXTRACTOR HOOD.
The manufacturer declares that this product meets all the
essential requirements for low voltage electrical material set
out in European directive 2006/95/EEC of 12 December
2006 and for electromagnetic compatibility as required by
European directive 2004/108/EEC of 15 December 2004.
If you need any technical help or would like more informa-
tion about our products, please do not hesitate to contact
our official distributor.
THE MANUFACTURER reserves the right to effect any
technological improvement or modification without
prior notice.
