ASSEMBLY
BEFORE INSTALL THE HOB, MAKE SURE THAT
The worktop is square and level, and no structural members interfere with space requirements.
The wall and the induced heating zone, near or above the worktop should be made of heat-
resistant material.
If the hob is installed above an oven, the oven should have a built-in cooling fan.
The installation will comply with all clearance requirements, applicable standards and regulations.
A suitable isolating switch providing full disconnection from the mains power supply is incorporated
in the permanent wiring, mounted and positioned to comply with the local wiring rules and
regulations. The isolating switch must be of an approved type and provide a 3 mm air gap contact
separation in all poles (or in all active [phase] conductors if the local wiring rules allow for this
variation of the requirements)
The isolating switch will be easily accessible to the customer with the hob installed.
Disconnection must be incorporated in the fixed wiring in accordance with the wiring rules.
Consult local building authorities and by-laws if in doubt regarding installation.
Use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall surfaces
surrounding the hob.
LOCATING THE FIXING BRACKETS
The unit should be placed on a stable, smooth surface (use the packaging).
Do not apply force onto the controls protruding from the hob.
The unit should be placed on a stable, smooth surface (use the packaging).
Do not apply force onto the controls protruding from the hob.
AFTER INSTALL THE HOB, MAKE SURE THAT
The power supply cable is not accessible through cupboard doors or drawers.
There is adequate flow of fresh air from outside the cabinetry to the base of the hob.
When installation above a drawer or cupboard space, a thermal protection barrier should be
installed below the base of the hob to avoid contacting the bottom of the hob.