Nodka TPC6000-C123-TH-BW5300U, User Manual

Page: 28 / 80

TPC6000-CXX3 User Manual
28
Step 2
：
Carefully mark the locations of the four bracket screw holes on the wall.
Step 3
：
Drill four pilot holes at the marked locations on the wall, for the bracket
retention screws.
Step 4
：
Align the wall-mounting bracket screw holes with the pilot holes.
Step 5
：
Secure the mounting-bracket to the wall by inserting the retention screws into
the four pilot holes and tightening them
Step 6
：
Insert the four monitor mounting screws provided in the wall mounting kit into
the four screw holes on the real panel of the flat panel PC and tighten until
the screw shank is secured against the rear panel
Step 7
：
Align the mounting screws on the monitor rear panel with the mounting holes
on the bracket.
Step 8
：
Carefully insert the screws through the holes and gently pull the monitor
downwards until the monitor rests securely in the slotted holes. And ensure
that all four of the mounting screws fit snuggly into their respective slotted
holes.
Step 9
：
Secure the panel PC by fastening the retention screw of the wall-mounting
bracket.
2.6.3 Panel mounting
To mount the TPC6000-CXX3 flat panel PC into a panel (not standard attached),
please follow the steps below:
Step 1
：
Select the location on the panel to mount the flat panel PC.
Step 2
：
Cut out a section from the panel that corresponds to the rear panel
dimensions of the flat panel PC. Take care that the panel section that is cut
out is smaller than the overall size of the metal frame that surrounds the flat
panel PC but just large enough for the rear panel of the flat panel PC to fit
through. Recommended cutout size as shown below: