OPERATION
16
265XP
(03-99)
TROUBLE SHOOTING –continued
PROBLEM
CAUSE
SOLUTION
Poor vacuum pick up.
Recovery tank lid not properly
sealed.
Insure float housing is in place and
locked.
Filter cage screen plugged.
Clean.
Recovery tank drain hose left open.
Replace cap.
Hole or leak in vacuum hose.
Repair or replace.
Blockage in pick up hose or wand.
Inspect hose and tool for blockage
and clean. Inspect recovery tank at
hose entrance for material pick up.
Low battery charge.
Charge batteries.
Leak in recovery tank.
Contact Service Center for assis-
tance.
Vac motor malfunction.
Contact Service Center for assis-
tance.
Electrical malfunction.
Contact Service Center for assis-
tance.
Squeegee streaks, uneven pick up.
Squeegee obstructed.
Check and clean tool and blades.
NOTE: Sweep floor before scrub-
bing.
Squeegee angle out of adjustment
Adjust to proper angle
Improper squeegee pressure
Adjust pressure
Squeegee blades worn
Reverse or replace
Inadequate squeegee lubrication for
floor conditions
Increase solution flow
Blades installed improperly
Refer to Squeegee Blade Installa-
tion Section of this manual
Batteries deliver below normal run
time
Batteries not fully charged.
Charge batteries.
time.
Electrolyte level is low.
Fill to proper level and charge (
DIS-
TILLED WATER ONLY).
Cables are loose or corroded
Clean and lubricate
Pad pressure too heavy
Reduce pressure
Improper pads causing too much
amp draw
Change to proper pads
Charger is defective
Contact Service Center for assis-
tance
Battery is defective
Contact Service Center for assis-
tance
