14
-
The temperatures, the weather conditions and all other conditions of employment must be within the normal
and never create any possibility of injury.
To adjust the height of the machine You should act on the control slides (see as described under "Adjustments
for working").
NOTE:
An optimal adjustment of speed and cutting height means less power used, extending the life of the
hammers and the whole machine and a decrease in consumption.
It 'can also obtain a greater commination, and then smaller and uniform, taking the tractor forward and with the
protection rotor hood closed (the rotor turns in the same way). This is possible with the material lying on the
ground or very high, or during the second pass.
In this case the material to be shredded remains longer within the frame-rotor and leaves finely chopped.
The power requirement with this type of work will be greater than working in reverse gear with protective hood
open.
The machine can also be equipped with the appropriate frame for branches abatement for high vegetation
which serves to channel branches to the rotor and to protect the cab and the operator tractor. Such equipment
should not be used to uproot trees, but just to keep branches and / or bushes in position until its are captured by
the processing of the hammers of the rotor.
The most comprehensive work is usually achieved by running two steps, first in reverse gear with protective
hood open while the second will be to march forward with the protective hood closed.
The tools is equipped the machine are suitable for working on soils of normal conformation. Check daily for their
integrity and wear. If at work were to break or crack accidentally, its must be replaced immediately taking care to
refit the new tools in the same position as those to be replaced.
Read carefully the chapter "Special maintenance”.
-
If the terrain has the minimum slope changes the machine will adapt itself to the new location. If the changes
were significant need to perform the work through the field from a different direction which does not present
large local gradients.
WARNING:
The slope of the land on which to pass the tractor must not exceed 10% in any direction. Be always
careful when you change direction in terms of slope and / or slippery.
Hilly terrain is advisable to use a tractor-wheel-drive, however, the tractor tires must always be able to provide
the necessary grip.
WARNING:
make sure that this path avoiding large rocks or holes which could compromise the stability of the
tractor causing the overthrow.
The Forestry shredder NOBILI S.p.A. can support very heavy work. In any case it is good to find a compromise
between power consumption, speed and quality of work. The advancement speed also depends on the initial
size of the mulch material and the desired degree of commination.
The advancement speed must always be limited and still should never pose a threat to anyone and for the
integrity of the machine. Be especially careful to ground conditions and further reduce the speed in this case is
rocky, muddy, etc..
It is left to each operator free to comprehensively assess these factors and determine from time to time the
correct speed.
CAUTION:
Never set and by no means any kind of load on your machine. Never transport a person or animal on
the machine. This also with the machine stopped.
WARNING
The maximum machine force should not never exceed the machine working capacity (see
"limitations" of this chapter)
Generally do not exceed the maximum speed ever shown in the table of technical data.
