NKT Photonics Koheras BOOSTIK, Product Manual

Page: 45 / 68

45
4 SDK Registers and Tabs
The Software Development Kit (SDK) allows access to registers controlling the
module’s operating parameters using its Generic User Interface (Generic UI)
application. For general operation it is recommended to use CONTROL. This
section’s purpose is to illustrate how to use the Generic User Interface to set the
laser’s operating parameters.
Table 7 presents the example registers by their
function with a link to a detailed description.
Table 7 Generic user interface registers
Note: This chapter introduces the Generic UI and its registers. For a full description of
the SDK, the module’s registers and using the Generic User Interface, refer to the NKT
Photonics document:
SDK Instruction Manual . The manual is installed when the SDK
installer is run.
SDK installer
The SDK installer including instructions is available at the following URL:
https://www.nktphotonics.com/lasers-fibers/support/software-drivers/
Register name and link Function Read/Write
Register
Read-only
Register
Unit
Output power setpoint
on page 46 Sets the emission output
power level. 22 & A0 – mW & dBm
Emission on page 46 Enables or disables
emission 30 – –
Setup bits on page 47 Configures the
operational mode, 31 – –
Stage one input monitor
on page 48 Displays the optical
input power received. – 10 mW
Pump temperature on
page 48 Displays the set pump
temperature. – 13 °C
Heat sink temperature
on page 49 Displays the rear
temperature sensor
measurement. – 1C °C
Errors and status
indicators on page 50 Boolean status
indicators and error
codes displayed – – –
Graphing on page 50 X-Y graphing of
selected registers. – – –