NKB PL2125, User Manual, Page: 22 / 30

22
While enter the dome limit setting menu, move the dome to the suitable position, and
press
【
Enter
】
to save and will show “Success" and back to previous menu.
Select the item 2 to set the Right limit, and do the same as the left limit setting,
Back to the menu and press
【
3
】
to operate the Run Scan
Attention
：
4.2.3 Pattern
Enter the menu as the Figure (4.1.1-1)
Press
【
2
】
enter the dome setting menu as the Figure
（
4.2.1-1)
；
And then press
【
3
】
enter the pattern setting as Figure 4.2.3-1
Figure 4.2.3-1
After enter the menu, the system need input the pattern information you want, you
can put in the Pattern ID (ID range base on the PTZ speed dome you use) and press the
【
ENTER
】
to confirm. The cursor will skip to the next item to set the PATTERN
information. If you already have it, you can skip it and select the
【
3
】
to run the pattern
directly.
Pattern setting
：
After enter the pattern setting menu, move the dome do the suitable
position and press the
【
1
】
to start record the pattern information. The screen will
display“Start …… ，
as the Figure 4.2.3-
2. Press“0 ” to finish the pattern record, and the
screen will show“Success” and back to the previous menu.
Figure 4.2.3-2
Attention:
Remark: While you want to run the PATTERN, you must set the STOP TIME and Speed in
each PRESET. Otherwise this function will not working.
4.2.4 Tour set up
Press
【
2
】
enter the dome setting menu, as the Figure 4.2.1-1 show,
And then press
【
4
】
enter the tour setting as the Figure 4.2.4-1 show.
Figure 4.2.4-1
While enter the dome SCAN menu, the keyboard navigate keyboard can directly control the dome; And the lens
control zone (Iris, Focus, zoom) also work available; And in other menu situation, normally the operation is NULL.
1. Pattern num:
2. Set pattern
3. Run pattern
Press 1 to start
Press 0 to start
Press PREV to back
While enter the dome PATTERN menu, the keyboard navigate keyboard can directly control the dome; And the lens
control zone (Iris, Focus, zoom) also work available; And in other menu situation, normally the operation is NULL.
1. Tour num:
2. Insert preset
3. Run tour