13
3.7 Drawing steam
➔
Then press the steam warm-up
button (fig. 1/P and 7).
➔
As soon as the system is ready,
“STEAM IS READY” and “TURN
VALVE” appear alternately in the
display.
➔
Hold a container with the liquid
to be heated under the jet (fig. 1/T).
➔
Dip the jet (fig. 1/T) into the
container with the liquid to be
heated.
➔
Make sure that the ‘spumatore’
control knob (fig. 11a) is pointing
to the neutral position (steam
symbol).
➔
Turn the steam / hot water valve
control knob (fig. 1/Q and 7) to
the right. Caution: A little water
will come out before the steam.
➔
The operation is completed by
turning the control knob back to
‘0’ (fig. 1/Q and 7).
Note:
· Steam can be drawn for about
2 minutes. Then the machine will
automatically switch the operation
off. You can prolong the operation
by turning the control knob
(fig. 1/Q and 7) back and forth.
·
Caution:
Risk of scalding!
The steam which comes out is
very hot. Only touch the black
plastic parts of the jet.
· It is hard to remove dried milk
left on the jet after frothing.
There fore clean the equipment as
soon as it has cooled down –
ideally repeat the steam drawing
operation with fresh, cold water
in a cup.
3.8 Frothing milk, hot milk and
cappuccino
With the special ‘spumatore’ /
frothing device (fig. 1/T and 8)
you can heat up milk straight from
the carton or container and then
froth it into the cup.
➔
Dip the inlet hose (fig. 11f)
straight into the milk carton or
container.
➔
Place a cup under the ‘spuma-
tore’ jet (fig. 1/T and 8).
➔
Then press the steam warm-up
button (fig. 1/P and 7).
➔
As soon as the system is ready,
“STEAM IS READY” and “TURN
VALVE” appear alternately in the
display screen.
... 3. Making coffee
Downloaded from CoffeeMachineManual.com Manuals
